FSA Cranks and BB

Jimmy Welch

Active Member
Hi Guys I'm replacing the chainring ony pals Cannondale it's got FSA 46 chainring and self thingy crank pushers sorry picture attached , when I roved the crank there was 2 spacers on the non drive side one hard plastic and the other steel , the steel one seemed very out of shape , is is meant to be like that , or shall replace with nice round one
 

Attachments

cyberknight

As long as I breathe, I attack.
is it a press fit BB ?
some have a wavy pre load washer on the non drive side
1631646273936.png
 

si_c

Guru
Location
Wirral
Put it on the left side last before fitting the arm.

Consequence would be improperly pre-loaded bearings in the bottom bracket and the crankset would have left to right play - you'd definitely notice this when riding.
 
OP
J

Jimmy Welch

Active Member
Put it on the left side last before fitting the arm.

Consequence would be improperly pre-loaded bearings in the bottom bracket and the crankset would have left to right play - you'd definitely notice this when riding.
Cheers does it go on inside or outside the other ring that's on there
 
OP
J

Jimmy Welch

Active Member
Cheers does it go on inside or outside the other ring that's on there
Sorry ignor that just re read you message it goes on last
 
OP
J

Jimmy Welch

Active Member
One last question the wave washer is there particular way round it goes in , is there a front and back to it ?
 
Top Bottom